迴轉盤式研掃機(MY-300)

ROTATING TABLE SHOT BLASTING M/C

本機乃針對大型而不適宜懸吊之工件或大型之薄形工件，放置於低轉速迴轉台上，再由設置於上方之噴砂葉輪，將鋼珠或鋁珠以高速且連續不斷射出珠擊工件表面工件可在短時間內將其表面所附著之鑄砂、毛邊、鏽皮、鱗皮去除，而呈現其美觀之清潔面，便於下一步驟之處理程序本機亦可加裝特殊夾具處理，如圖示之長型工件，亦適於彈簧噴韌使用。

  

This m/c is against the large workpiece which is not suitable to hang for handling or large but thin ribs workpiece those aredeposited on the rotating table at low speed, meanwhile, the workpiece surfacewill be shoted steel ball by shot wheelabrators in hi-speed and continuously, after then, the casting sand, scaling & burring etc., which adhesived on the workpiece surface will be cleaned in short time, the processed workpiece will be shined & burnished and convenient for next step processings.

This m/c can be installed special fixtures tohandle long profile workpiece as fig shown, Especially, which can be employed for spring to shot peening use.

本機型規格一覽表：

型式 Model		MY-300
研掃動力 Shoting power		7.5HP*2~3 / 10HP*2~3
最大承載重量 Max.load capacity		500kg
最大承載高度 Max.load height		500mm
工作台直徑 Working table dia.		1300mm/1500mm/1700mm
工作台動力 Working table driving power		1HP
提砂動力 Elevating shot power		1HP
集塵機動力 Dust collector power		2HP
佔地面積 Userfloor space (LXW)		6M2
淨重 N.W.		3500kg